 |
Techno Teaboy |
Joined: Sat Feb 25, 2006 2:59 pm Posts: 13 Location: Greenhithe, Kent
|
Assuming you're talking about a 1541 disk drive, the easiest way was to open up the bottom of the drive and move one of the jumper switches.
By default all should be closed, so flicking jumper 1 should change the device number to 9.
You could do this also with a print command to the drive, although I think you'd need to do this each time you turned the drive on.
I'm sure there's probably a scanned copy of the drive manual out there somewhere!
Hope this helps.
|
|